coppo1
14-07-2006, 05:43 PM
here is a fun one i just found out during testing of an old project.
If you have V302 firmware in the controller but are running the
V404 software to program it, the "quick toggle" feature on a C-Bus group
address does not work correctly.
If you:
quick toggle "OFF"--- no problems
Quick toggle "ON" --- it sets the GA to approx 16-18%.... not 100%.
update your firmware in the controller to V404 firmware
and the quick toggle functions correctly.
this is a typical one for all of you out there that
clicked the auto pop-up reminder for firmware updates and said
"don't check for firmware updates between controller and software".
If you have V302 firmware in the controller but are running the
V404 software to program it, the "quick toggle" feature on a C-Bus group
address does not work correctly.
If you:
quick toggle "OFF"--- no problems
Quick toggle "ON" --- it sets the GA to approx 16-18%.... not 100%.
update your firmware in the controller to V404 firmware
and the quick toggle functions correctly.
this is a typical one for all of you out there that
clicked the auto pop-up reminder for firmware updates and said
"don't check for firmware updates between controller and software".