C-Bus with Dimmable LED lights

[George]

Anyone had any fun with these, it seems to be a bit of a trick to dim LEDs.

[Forumadmin]

Hi George,
Last time i checked there was not a cbus dimmer capable of doing the job.
In short Clipsal don’t have a din range dimmer that will do the job at the moment.

If you had the time and the energy you could try using a 0~10V output into a pulse width modulator then to the LED's. This should work OK as a stop gap if you are desperate. Pulse width modulation of a power supply (other wise known as PWM's) is what some companies use to dim LED's. Good luck.

[Frank Mc Alinden]

Hi George

If you have a pc in your setup you could use these.....

http://www.hobby.armaghelectrical.com.au/page90.html

Frank