Forumadmin
08-06-2004, 12:18 PM
For those that did not recieve an update notice:
The following products or updates are now accessable from the CIS downloads page.
http://www.clipsal.com/cis/downloads.php3
CGate Version 1.5 Full Build, single network ( build 1098) ( 30MB file size )
CGate Update ( Build 1099 ) ( 300 kb file size )
IR Reader V1.1 ( 2MB file size )
when creating or learning IR buttons, "naming" the button appropriately will enable a specific relevant icon to be displayed next to the button. A preview table displays the names to icon relationship. Previously these icons were only displayed once the IR codes had been imported into CIRCA.
USB drivers are now installed as part of the IR Reader installation.
Software is now easier to use without requiring the "wizard" ( wizard is still accessable though)
Learning process is now simplified
Slightly longer IR codes may be learnt than previous IR software version.
C-Bus diagnostic Utility Version 1.4 ( 600kb)
Added support for CNIs.
Added function to display network voltage of all units on a network.
Allow use of remote C-Bus networks (via C-Bus bridges).
Monitoring C-Bus messages.
Creating C-Bus Lighting and Control messages.
Message logging.
Setting PC Interface Modes.
C-Bus Traffic analyser.
This program is handy for people who previously were using hyper-terminal or CGate to view what was happening on the C-Bus network.
The following products or updates are now accessable from the CIS downloads page.
http://www.clipsal.com/cis/downloads.php3
CGate Version 1.5 Full Build, single network ( build 1098) ( 30MB file size )
CGate Update ( Build 1099 ) ( 300 kb file size )
IR Reader V1.1 ( 2MB file size )
when creating or learning IR buttons, "naming" the button appropriately will enable a specific relevant icon to be displayed next to the button. A preview table displays the names to icon relationship. Previously these icons were only displayed once the IR codes had been imported into CIRCA.
USB drivers are now installed as part of the IR Reader installation.
Software is now easier to use without requiring the "wizard" ( wizard is still accessable though)
Learning process is now simplified
Slightly longer IR codes may be learnt than previous IR software version.
C-Bus diagnostic Utility Version 1.4 ( 600kb)
Added support for CNIs.
Added function to display network voltage of all units on a network.
Allow use of remote C-Bus networks (via C-Bus bridges).
Monitoring C-Bus messages.
Creating C-Bus Lighting and Control messages.
Message logging.
Setting PC Interface Modes.
C-Bus Traffic analyser.
This program is handy for people who previously were using hyper-terminal or CGate to view what was happening on the C-Bus network.